~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~ [ freetext search ] ~ [ file search ] ~

Linux Cross Reference
Linux/Documentation/sound/CS4232

Version: ~ [ 2.4.0 ] ~
Architecture: ~ [ i386 ] ~ [ alpha ] ~ [ m68k ] ~ [ mips ] ~ [ ppc ] ~ [ sparc ] ~ [ sparc64 ] ~ 
  1 To configure the Crystal CS423x sound chip and activate its DSP functions,
  2 modules may be loaded in this order:
  3   
  4         modprobe sound
  5         insmod ad1848
  6         insmod uart401
  7         insmod cs4232 io=* irq=* dma=* dma2=*
  8   
  9 This is the meaning of the parameters:
 10   
 11         io--I/O address of the Windows Sound System (normally 0x534)
 12         irq--IRQ of this device
 13         dma and dma2--DMA channels (DMA2 may be 0)
 14   
 15 On some cards, the board attempts to do non-PnP setup, and fails.  If you
 16 have problems, use Linux' PnP facilities. 
 17   
 18 To get MIDI facilities add
 19   
 20         insmod opl3 io=*
 21   
 22 where "io" is the I/O address of the OPL3 synthesizer. This will be shown
 23 in /proc/sys/pnp and is normally 0x388.
~ [ source navigation ] ~ [ diff markup ] ~ [ identifier search ] ~ [ freetext search ] ~ [ file search ] ~
This page was automatically generated by the LXR engine.
Visit the LXR main site for more information.